涂层干燥和固化的各个阶段很容易监测,但是要用根据化学和物理原理的术语来定义它们就不那么简单。为了能够得到满意的评估,就需要在控制的条件下使用仪器来测量,依据ASTM D 5895 Gardco公司提供多种用途的干燥时间记录仪来帮助定量干燥和固化的不同阶段,产生重现性好的结果,并保证zei高的效率 典型涂层干燥过程的四个阶段: 第一阶段:A pear shaped impression corresponding to the time taken for evaporation of the solvent 第二阶段The cutting of a continuous track, corresponding to a sol-gel transition 第三阶段An interrupted track corresponding to the surface-dry time 第四阶段The needle no longer penetrates the film, corresponding to the final drying time
如下图:
操作步骤: 1使用涂膜器及支架在玻璃片上涂膜 2将仪器杆放在起始位置,将玻璃片放在其位置上 3将划针放在样品玻璃上,调整速度钮选择合适的速度 4打开干燥时间记录仪—仪器将会在测试终点自动关闭 5依据ASTM D 5895测试规范评判待测样品板的干燥时间
DT-BK3干燥时间记录仪有三个不同的速度:6-12-24小时,可适合任何应用
DT-BK3干燥时间记录仪基本配置如下: 干燥时间记录仪 6块玻璃片,6个划针
订货说明:(特别说明:Gardco还提供特殊记录周期(0.5小时----96小时)的定制)
货号
简单描述
DT-BK-3
6-12-24 hrs, 3-6-12 hrs , 12-24-48 hrs
Special: 1/2-1-2 hrs, 1-2-4 hrs , 2-4-8 hrs , 24-48-96 hrs. Special Single Speed (Additional Cost):12 minute, 24 minute or 48 minute.